EisSound 400 Series Manual de instalación descargar pdf (Pagina 48)

An intercom call to a zone group is a call transmitted from a Control Unit

and received by the Control Units under the same group (see 4.1.6.B ó

4.1.8.B Control Unit Installation: Group)

A general call is a call to group #0. All the Control Units belong to group

#0 and therefore receive the intercom call unless inercom call reception is

blocked at that time (see 4.1.3.H. Permissions for Intercom Calls

Operations).

The key switches between “individual identification” and

“group identification”. The zone identification number keyed will be

read as individual or group depending on the “gr” status on the

display.

Pressing the group key in general calls is redundant because

identification 0 only refers to group identification or general calls

(zone 0 does not exist).

4.1.3.B. General Calls And Zone Group Calls

Auto response is not possible in this type of calls.

The volume of the intercom call received is the volume programmed in

sections 4.1.4.H or 4.1.7.G Receive Intercom Calls Volume. To adjust

the volume, use the +/- keys while the intercom call is being received

(when the intercom call is over, the volume setting will be stored in

memory).

Changing the intercom call receipt volume

Either of the two parties may initiate a conversation at any

time by pressing the key.

Either of the two parties may end the intercom conversation at

any time by pressing the key.

When said key is held , further to canceling the receipt of the call, the control unit will switch to “do not disturb” mode.

The maximum duration of an intercom operation (calls + responses) is 3 minutes.

Initiating a conversation

Ending an intercom call operation

It is possible to totally or partially block the call/auto-response process.

See 4.1.3.E.”Do not disturb” function and 4.1.3.H. Intercom Call

Permissions.. When a Control Unit cannot receive intercom calls, the

icon will be lit if the block is permanent or flashing if the “Do not

disturb” function is activated.

2’’

CC-1023ENG-10

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

Sin comentarios

EisSound 400 Series Manual de instalación Pagina 48