EisSound 400 Series Manual de instalación descargar pdf (Pagina 82)

4.2.2.F. Alarm

4.2.3. Operating intercom calls functions

4.2.3.A. The Key: Entering the Intercom Calls Mode

The intercom calls mode is reached by pressing the key for 2” (the unit can be on or

off). Once in intercom calls mode, release the key. Using the +,- keys, you can change

to 4 operating modes:

Key Sequence Display Visual

ADDRESs

grOUP

ADR 02

gEN’L

CALLs

Last call made (for example, to zone 2)

general call

individual call

group call

2’’

The 428A1 Control Unit is equipped with an

alarm that can be programmed and can

operate in two different modes:

Operates only when the Control Unit is off.

At the time programmed, the Control Unit

switches on with the last music channel

played.

The volume is programmable

“Music” mode alarm:

“Beep” mode alarm:

Operates whether the Control Unit is off or on

At the time programmed, the Control Unit switches on and a specific beep signal is

activated.

Is equipped with a “delay” function: a short key press of any key returns the Control Unit

to its previous state (standby or music) and after 4' the beep signal is activated again

To cancel the alarm, press any key until a continuous beep sounds: it will return to its

previous state (standby or music) and the alarm function ends. The snooze function may

be cancelled at any time by holding down the ON/OFF key for 2 seconds

If the Control Unit is powered off or on during the “delay” period, the alarm function

ends.

Also, if 4' elapse without any key press, the Control Unit returns to its previous state

(standby or music) and the alarm function ends

See Program Menu (4.2.4.A.)

CC-1023ENG-10

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 99 100

Sin comentarios

EisSound 400 Series Manual de instalación Pagina 82